10/15/18 16:00 PM  

Deslphones - Manual Provisioning | Linksys PAP2-NA-ATA | RingCentral

« Go Back

Article

 
SummaryHow do I manually provision a Linksys PAP2-NA-ATA?
Details
This article will guide you on how to manually provision a Linksys PAP2-NA ATA.

To do this, follow the steps below:

 
Step 1:
Plug an Ethernet cable from the router's Ethernet port to the Linksys PAP2-NA ATA.


Step 2:
Get the device’s IP address by going through the phone menu:

 
Dial * four (4) times.
Dial 110# and take note of the IP address.
 
Step 3:
On your computer, launch your web browser then enter the IP address in the Address bar.

NOTE:  We use http://192.168.1.101/ as an example.
  A Username and Password is required to access the user interface.

 
User-added image

Step 4:
Click on Admin Login.
 
User-added image
 
Step 5:
Click on switch to advanced view.

 
User-added image

Step 6:
Click on the Line 1 tab.

 
User-added image

Step 7:
Enter the SIP configuration information you have obtained from your online account.

NOTE:  To learn how to check your SIP Confirguration information from your online account, click hereThe User ID is also the RingCentral Digital Line phone number.  The Password and Authentication ID is always the same.

Step 8:
Auth ID, Block CID Serv, Dist Ring Serv should be set to yes.

 
User-added image

Step 9:
Click on Save Settings.  The device will automatically reboot and the settings on the IP phone will be updated.

You have have now manually provisioned a Linksys PAP2-NA ATA.
 
Ranking
Was this information helpful?
Yes
No
Somewhat

Tell us why and what can we do to improve this information