11/18/19 11:54 AM  

Call Quality - VoIP Quality of Service | Frequently Asked Questions | RingCentral

« Go Back


SummaryCall Quality | Voice Over IP | Quality of Service


1. What are some of the factors affecting the VoIP Quality of Service (QoS)?
2. What are the top issues encountered with VoIP calls?
3. What cause these issues?
4. How do I resolve these issues?
5. What is the recommended bandwidth to support VoIP service?
6. What are the minimum requirements for an optimal call quality experience?


1. What are some of the factors affecting Call Quality | VoIP Quality of Service (QoS)?

RingCentral’s voice service is VoIP-based (voice over IP), where ALL calls traverse through your internet connection, to RingCentral (for call processing/management), then onto your destination caller’s network/phone.

Because the sound of your voice (and others) is converted into thousands of packets, many factors can affect the packet transport, impacting the call quality. The three (3) most common factors that affect call quality are Latency, Jitter, and Packet Loss.

• Latency

Latency (also known as delay) refers to the time it takes a voice packet to reach its destination. Latency is measured in milliseconds (ms) (or thousandths of a second). Latency of 150ms or less (one-way) is generally acceptable. Latency greater than 150ms (again, one way) adversely affects the call quality experience.

• Jitter

Jitter is the variation in the arrival rate of packets at a destination point. Jitter is often caused by network congestion, timing drift, or route changes. Jitter is also measured in milliseconds (ms) (or thousandths of a second). Jitter greater than 30ms may result in packet drops thus impacting call-quality experiences.

• Jitter Buffer Discard rate shows the percent of delayed packages that were discarded because of long delay time.

• Packet Loss

Packets are sent over the Internet and reassembled at their destination. Packet loss (also known as data loss) occurs when some packets are dropped by congested network routers or switches, or discarded by the jitter buffer. The effects of this may be the loss of syllables or even missing words during a conversation.

2. What are the top issues encountered with VoIP calls?

The top issues or call-quality affecting symptoms that you may encounter during a call:


3. What cause these issues?

For Choppy/Dropped/Delayed/Garbled:

Network congestion/delay leading to dropped packets (Local Area Network (LAN) related issues)

Lack of bandwidth/unable to support simultaneous calls (Internet Service Provider (ISP) related issues/ Internet connection issues)

Inconsistent ISP/throughput performance (ISP/ Internet connection issues)

For Static/Echoing:

(static) Loose interfacing connections (phone/handset/wall-jack).
(static) Malfunctioning handset or phone-set.
(static) EMI/Electromagnetic interferences such as non-LCD TV and monitors, light fixtures, etc.
(echo) combination of delay/sound volume setting/ and/or use of speakerphone.

4. How do I resolve these issues?

For Choppy/Dropped/Delayed/Garbled:

To isolate the issue, you can check on the following:

1. Are you the only one experiencing this or is it affecting other phones?  

2. Any recent changes to your local network? Changes may include the following:

added a file server to the local network
• added/changed a network switch/router/firewall
• changed Internet Service Provider  

If there are no recent changes, follow the suggestions below:

Check the performance of your Internet connection

If your ability to connect to websites and/or data services is limited at the moment along with poor call-quality experiences, you may want to contact your IT Administrator, or your Internet Service Provider (ISP) to check on your internet connection. If you are able to connect to the internet fine (i.e. to websites and data services), run 3 to 4, consecutive speed tests via www.speedtest.net, to measure the performance of your Internet connection. The performance may have been degraded to a point where it is contributing to ‘packet loss’ and/or ‘jitter’, which in turn will affect call-quality performance; voice traffic is highly sensitive to network performance degradations. 

What to look for in the speed test results?  

To make use of the results, you will need to know what your provisioned bandwidth/speed is; that is what bandwidth/speed are you paying for when you signed up with your ISP. The speed test results will show the following 3 parameters: 


The Ping results reflect the overall delay in the network. The Ping results should be under 60ms; normal can range anywhere between 5ms to 48ms, as it depends on your connection with the ISP.


The Download/Upload results should be no less than 75-80% of your provisioned speed. Perform 3 to 4 consecutive speed tests noting consistency in the result, and that the performance is not fluctuating 20% (increase or decrease). If you are getting inconsistent results or if your Actual speed is 75-80% less than your provisioned speed, you may need to contact your ISP to check the performance you are seeing vs what you are paying for. If possible, determine options to get a Business-level service agreement with your ISP. You may have to pay a bit more for the service, however, it will ensure that they provide to the level of performance you are paying for consistently.

Set your Router to Prioritize Voice-related Traffic

Ensure that ‘prioritization’ is configured for the voice-related traffic AND that a ‘minimum guaranteed bandwidth’ for this prioritized traffic is set, on your router/firewall. In most Small Office Home Office (SOHO) routers, these QoS-related features are located in the QoS/Traffic Manager section of the router. Consult the manufacturer of your router for instruction on setting up the prioritization.

• For Static/Echoing:

Follow the troubleshooting steps as listed in the above section (‘For Choppy/Dropped/Delayed/Garbled’), to confirm that your router has been configured to prioritize the voice traffic and that a minimum guaranteed bandwidth for this prioritized traffic is set. This is also to ensure that your Internet connection is performing as expected.

If you are experiencing these symptoms while on your handset, put the call on speaker and see if the issue still persists and vice versa. Check the physical connection of your handset to and from the base, as well as the Ethernet connection from that base to your network switch or wall-jack. Ensure that the cables are connected securely and that they are away from sources of electromagnetic interference (i.e. light fixtures, power supply and monitors).  This is to isolate the problem between a faulty handset and speaker. Desk phones provided by RingCentral are covered by warranty up to one year from the date of purchase.

Echoing may be experienced if one or both parties in the call are on speakerphone, and the speaker volume is set to moderate or very load. This may also be caused by higher than normal delay relative to network performance. To resolve this, reduce the speaker volume or use the phone handset. If the delay is severe, run a set of speed tests through speedtest.net to confirm the Internet connection performance. If the delay if your ISP connection-related, please contact your ISP to resolve the performance matter.

5. What is the recommended bandwidth to support VoIP service?

An Internet connection that is stable and consistent in performance is required to ensure good voice quality. It is recommended to have a high-speed DSL, cable or fiber connection with enough bandwidth to accommodate both your regular internet traffic and the number of simultaneous voice calls. A connection with a Business-level service agreement is preferable, though not required. RingCentral calls require 92Kbps per call (100Kbps/call, for ease of calculation;  via G.711 or G.722). A speed test can be performed via www.speedtest.net to confirm your bandwidth.

NOTE: If the speed testing shows poor performance, i.e. expecting 1.5Mbps, but getting only 800Kbps, or ping results are above 100ms or are dramatically inconsistent between pings (especially if in the US), please contact your Internet Service Provider (ISP) to improve your Internet connectivity.

6. What are the minimum requirements for an optimal call quality experience?

Below are the minimum requirements for an optimal call quality experience.

• A reliably performing internet connection with sufficient bandwidth to accommodate 'x' amount of anticipated, concurrent calls. 

• If a firewall or network-security implementation is employed, please ensure that you are allowing the needed ports in/out of your network.

• Enable 'traffic prioritization' - giving voice-packets priority over data packets.

• Set a minimum-guaranteed-bandwidth, for the prioritized traffic. 

• Ensure that the 'Bandwidth Settings' to your phones, is set to 'High', if not already set.

See RingCentral Network Requirements and Recommendations for more information.

See Also

Deskphones - Basic Troubleshooting for your IP phones | RingCentral

TitleCall Quality - VoIP Quality of Service | Frequently Asked Questions | RingCentral
URL NameVoIP-Connectivity-Issues
Was this information helpful?

Tell us why and what can we do to improve this information